Friday, August 4, 2023

Second "Quilt As You Go" (QAYG) Almost Done and How I Do them!

 

1.  Place the one inch strip of the sashing for the right side on top and a folded 1 5/8 in strip of the sashing for the back on the right hand edge of the first square, making sure the open edge of the back sashing is at the edge of the square.  Pin in 3 places.

2.  Sew through all the pieces 1/4 inch from the edge.

3. Take the second square and arrange the top sashing along the edge, again placing three pins and then sew in place a 1/4 in from the edge.  This leaves 1/2 in of sashing on the front all finished.  Now to finish the sashing on the back.

This is how it should look at this point with the second seam in the front sashing completed.


4.  Now open up the two squares and pin down the back sashing in three places and sew fairly close to the right edge making sure you have matching thread on the back and the front.

This is what the back looks like finished.
If you are really likely, you can get the sewing right in the ditch but here it is on the front sashing and sometimes it sits on the finished part of the block.  It really doesn't show too much if you use thread that is a neutral on the front.


Once you have all the rows completed, do the same steps to sew the rows together.  The only additional thing to be mindful of is that try your best to get the vertical sashing lined up, both front and back.  I am sometimes more successful at that than others but again, it is a little annoying but probably not too bad!


Here is the front except for the binding for QAYG2.  I used blue sashing for this one and will use the same fabric for the binding.



This is the back of QAYG2 and I used all different squares for this one but still didn't arrange them in any kind of order.







No comments:

Post a Comment